LumberJocks

Reply by Sawdust35

  • Advertise with us

Posted on Crown too thin after changing spring angle?

View Sawdust35's profile

Sawdust35

71 posts in 1427 days


#1 posted 09-13-2017 09:59 PM

I hope the following helps the OP.

A large room in my house has a ceiling that is out of level by 1”. I used a Bosch GLL2-10-RT laser level to survey the ceiling since I needed to install crown. Where there were gaps over 1/8” I glued a filler piece of 1x material to the top of the crown, scribed along the ceiling and cut off the waste. If the filler piece protruded from the front edge of the crown, I used a top bearing flush trim router bit to fix the overhang. I’ve included a few pictures of the finished product.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com