LumberJocks

Reply by fivecodys

  • Advertise with us

Posted on Crosscut sled issues

View fivecodys's profile

fivecodys

1662 posts in 2522 days


#1 posted 08-25-2017 08:00 PM

I had this happen to me. What I did was to take a sharpie and run a line down each side of the runners and then place the sled back in the miter tracks. I shoved it back and forth and then checked to see where the sharpie had been rubbed off or smeared. I took a cabinet scraper and sandpaper and worked on that spot a little and then started the process all over again until I had it moving smoothly again.
Go easy or you will take off too much and then when the humidity goes down it will be sloppy lose.

Next time I will use LDPE or an old cutting board to make the runners.

-- A bad day woodworking is still better than a good day working.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com