LumberJocks

Reply by fazhou

  • Advertise with us

Posted on How reinforce box miter joint?

View fazhou's profile

fazhou

17 posts in 2473 days


#1 posted 08-14-2017 07:32 PM

Thanks for the replies. The back (bottom) will not be glued in but screwed in place. In a rabbett of course. So the dowel idea is not dowels in the endgrain, but rather, after the box is glued up, drill a hole in the edge, centered on the miter from the back and then a dowel glued in the hole. The epoxy bit is very relevant in this case. It would be like a spline but much easier. I’m not sure how I would cut a blind spline in something so narrow. And if I did do a blind spline, it would have to be rounded to accommodate a table saw kerf, correct?


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com