Reply by SuperCubber

1164 posts in 3259 days

#1 posted 08-14-2017 01:59 AM

Not sure this is the best solution, but it could work:

Drill out the elongated holes on the sides through the top layer of the bread board and the tenon. Glue a short dowel to the bottom layer of the bread board only, then drill a larger, round hole on top and “plug” it with a larger dowel.

Hope that makes sense!

-- Joe | Spartanburg, SC | "To give anything less than your best is to sacrafice the gift." - Steve Prefontaine

Go to Pulse page »

LumberJocks Pulse

	Author	Latest activity	New comments or replies since you last checked
SMALL BOWL	Ivan	01-25-2021 11:02 PM	sign in to get readership tracking
Router Table	DeLaMadera	01-25-2021 11:00 PM	sign in to get readership tracking
Scottish Gnome	blmac4	01-25-2021 10:54 PM	sign in to get readership tracking
Orbit 1412 - Drill Press - Motor Replacement	racielrod	01-25-2021 10:46 PM	sign in to get readership tracking
Bulldogg45's Profile	Bulldogg45	01-25-2021 10:46 PM	sign in to get readership tracking
Ben 's Profile	Ben	01-25-2021 10:45 PM	sign in to get readership tracking
DeLaMadera's Workshop	DeLaMadera	01-25-2021 10:43 PM	sign in to get readership tracking
Arts And Crafts Bathroom Vanity Convention	James E McIntyre	01-25-2021 10:39 PM	sign in to get readership tracking
Restoring an old Drill Press - Chuck recommendations	racielrod	01-25-2021 10:37 PM	sign in to get readership tracking
Whimsy jewelry box	mjon	01-25-2021 10:34 PM	sign in to get readership tracking

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics