LumberJocks

Reply by dhazelton

  • Advertise with us

Posted on chamfer on table top

View dhazelton's profile

dhazelton

2839 posts in 2840 days


#1 posted 07-16-2017 12:48 PM

Figure out what that angle is by drawing it out on a piece of paper. Then either cut it with a circular saw or table saw with the top standing on it’s thickness (you’ll have to clamp support material on the edge if you use a circular saw to keep the sole plate flat). You’d have to start and stop short and finish it with a hand saw. Unless you can find a router bit close enough to that profile to run it through a router table or shaper. You’ll still have to finish with a hand saw if the chamfer is suppose to end squared off.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com