Reply by Pete_LJ

  • Advertise with us

Posted on Grizzly G1022Z Blade Parallelism

View Pete_LJ's profile


109 posts in 1225 days

#1 posted 06-13-2017 10:14 PM

New problem: I tried adjusting table top with dead-blow hammer with three loosened bolts (described above) and now the blade will no longer go to a 90 degree angle. I have tried adjusting the bolt and jam nut that adjust the pinion gear that translates motion to the trunnion but this has not solved the problem even when loosened all the way. It looks like I am going to have remove the saw from the stand to fix this new problem before I can proceed.

I found out that the pinion gear is held onto the shaft actuated by the right hand wheel (90 degree to 45 degree angle adjustment). Found some new fasteners on the mounting block for bearing of angle shaft. Once inside I found that he pinion shaft roll pin is sheared and hence the angle adjustment problem. Looks I need to get the sheared pin out of the hole for pinion gear, obtain new roll pin (appears to be 2.5mm) and then reassemble.

I will post some pics later.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics