LumberJocks

Reply by richardatkinson

  • Advertise with us

Posted on Air Compressor filter/regulator & LVLP setup

View richardatkinson's profile

richardatkinson

12 posts in 1339 days


#1 posted 02-21-2017 08:58 PM

Thanks Earl, very helpful.

Just to go into a little more detail. with the hose/equipment I have already purchased for line (B) the paint line.

Firstly all my hoses have 1/4 BSP nuts, so my hose length are fairly fixed (apart from adding two together if needed)

I have: two 32ft fairly stiff hoses with a (9mm) 23/64 bore – which I was going to use either 1 (32ft) or both (64ft) joined together before the filter/regulator

one 16ft more flexible hose with a (8mm) 5/16 bore – which I thought would be good from the regulator/filter to my spray gun. (I do have a regulator on my gun so I can see if there is a pressure drop from the wall mounted regulator/filter).

so my main question now (in more detail) is should I use: one of the 32ft hoses before the filter/regulator both 32ft hoses to make 64ft in total neither hoses at all and splash out another about $150 on copper piping?

Also I did read somewhere that looping the system was good for no pressure drop, but I didn’t think this suited my equipment/layout!

No problem with using multi lines at the same time as its just me using the whole system.

Thanks again for any advice in advance :)

-- Love wood


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com