LumberJocks

Reply by robscastle

  • Advertise with us

Posted on Sanding Belts - Storage Ideas Sought

View robscastle's profile

robscastle

7515 posts in 3119 days


#1 posted 01-25-2017 11:18 PM

Guys I have a fairly complex workshop setup so if you check out picture No2 in my workshop it shows the original way I used the linisher.

I am not suggesting leaving them under tension is a single point of failure however add Mr sunshine and then the problems occur.

One day I was standing in front of my linisher and powered up and shortly after received a surprise turkey slap from a separating belt of which was definately a joint failure.

I swapped a belt from down below, a virgin one and fitted it up stood to one side powered it up and sure enough it tried to get me again with another turkey slap.

A total stock loss occured from all of them

-- Regards Rob


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com