Reply by DocSavage45

  • Advertise with us

Posted on Aligning my Grizzly GO555 cast iron table?

View DocSavage45's profile


8932 posts in 3583 days

#1 posted 01-20-2017 09:37 PM


Thanks for asking and throwing out some questions I believe I did all you asked, and I will recheck it. The miter gauge gets stopped against a slight difference in the back. As I mentioned to Greg I used a good straight edge too.

Alignment appears OK as I successfully sliced some fairly thin Black Walnut veneer which was equal in dimension from beginning to end cutting.

-- Cau Haus Designs, Thomas J. Tieffenbacher

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics