Reply by Jack Lewis

  • Advertise with us

Posted on Segmented turning question

View Jack Lewis's profile

Jack Lewis

576 posts in 2326 days

#1 posted 12-14-2016 06:31 PM

I used to sand the rings but now I just hot glue them to a MDF piece, with concentric ring marks, on a faceplate and scraper/sand with a flat board. Then use it to center, glue and clamp onto the base assembly using the tailstock to apply pressure. Went this route because the Jet drum sander was such a bit*h to change the drum when the glue clogged the grit.

-- "PLUMBER'S BUTT! Get over it, everybody has one"

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics