LumberJocks

Reply by jerryminer

  • Advertise with us

Posted on Paste wax application to cast iron saw table

View jerryminer's profile

jerryminer

960 posts in 1955 days


#1 posted 10-20-2016 08:13 AM

The way I do it is use a piece of an old T shirt, place a small lump of wax (like a tablespoonful) inside the rag, wrapping the cloth around the lump of wax, and wipe a thin layer onto the table surface, allowing the wax to ooze through the cloth.

Then wait a few seconds for the solvents in the wax to “flash off” and buff with a clean cloth. There should be no residue left behind, just a shiny, slippery table surface.

You can open up the rag after application and scrape the remaining wax back into the can before it dries out and gets hard.

Been doing it this way for decades. Works great for me. HTH.

-- Jerry, making sawdust professionally since 1976


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com