LumberJocks

Reply by Jim Dawson

  • Advertise with us

Posted on Transpower 6" Jointer question...

View Jim Dawson's profile

Jim Dawson

114 posts in 1251 days


#1 posted 08-20-2016 05:50 PM



$150 max a China/Taiwanese clone, close up the ends and bottom, with 1/4, plywood and put a 4” dust,chip collector on the back side been there, done it.

- nightguy

I’ve been playing around with dust removal today. I haven’t figured out how to seal the ends yet. I want to do it on the inside as it spews enough chips out the ends that it packs it in around the mechanism that raises the infeed table.

There is no ramp to direct the chips to I added one temporarily with duct tape and it seems to direct it towards the dust port I added but a lot still comes out through the end.

Any suggestions would be appreciated.

Jim


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com