LumberJocks

Reply by Aj2

  • Advertise with us

Posted on Table Saw tricks & tips suggestions

View Aj2's profile

Aj2

3502 posts in 2716 days


#1 posted 08-20-2016 03:28 AM

I had a Bosch table saw for a. Short time and thought it was very good for a Job site saw.
If your trying to get a good cross cut with the sloppy miter gage then forget about it.
Buy a after market gage that you can adjust.I had a kreg.One for both sides.
If you cannot get a square rip using the fence then you should only adjust the fence to the miter slots first.Do not mess with the trunnions.
Mine was perfectly adjusted at the factory but the fence needed attention.
Also you should be checking your cut on a piece of wood that is flat and square.
Your square needs to be square too.
Dont mess with the trunnions until your sure.In fact take the saw back if they are not in alignment.

Aj

-- Aj


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com