LumberJocks

Reply by HokieKen

  • Advertise with us

Posted on Table Saw tricks & tips suggestions

View HokieKen's profile (online now)

HokieKen

15311 posts in 2052 days


#1 posted 08-18-2016 07:10 PM

It depends on how your cuts are out of square. Top to bottom or side to side? If top to bottom, it’s a matter of tweaking your 0 stop on your bevel. Best to have an angle gauge of some sort but can be done by trial and error if you’re patient and methodical. If it’s side to side, it’s a matter of tweaking the 0 setting on your miter gauge.

Another consideration is whether or not your out-of-square cuts are consistent. Is the angle off the same amount in the same direction consistently? If not, it may just be a flimsy miter gauge or a sloppy fit in the miter slot.

How are your rip cuts? Be careful that you don’t heel the fence and cause binding on the back side of the blade. It can cause kickback which can be very dangerous.

-- Kenny, SW VA, Go Hokies!!!


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com