LumberJocks

Reply by ErichK

  • Advertise with us

Posted on What's a good aftermarket tables fence?

View ErichK's profile

ErichK

80 posts in 990 days


#1 posted 08-16-2016 12:00 AM


Delta T2/T3 is a pretty popular one. I have one that I m just upgrading out of at the moment, but besides a handful of small annoyances it is a great fence. Can be had new for ~$200.

Finding a used-fence can be hard, though if you re in the Portland Oregon area….

- ErichK

Any idea if theT2/T3 would do a direct bolt on replacement for an older Delta/Rockwell 10” contractors saw ? I tried to find out what the spacing on the bolt holes on the T2/T3 are but couldn t find it.

- Richard

I don t know for sure, but I installed it on a Craftsman 113. It required a few holes to be drilled in the cast iron, which is actually incredibly easy to do. I clamped the rails to the table, marked them, and drilled. I did 3 sizes of bits to make it easier to get through, but it otherwise was really easy.

- ErichK

Can you measure the distance between the stock holes on the T2/T3 you have ? I would rather not have to drill and tap any holes in the table since I am not really setup to do that.

- Richard

Measurements from left of rail:
2.75
6.125
7.18
13.25
29.25
33
36.375
37.375
42.92
47.375


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com