Reply by CharlieM1958

  • Advertise with us

Posted on Kick back on router table

View CharlieM1958's profile


16283 posts in 4611 days

#1 posted 05-09-2011 08:51 PM

I agree with David and Loren. !/8” is not too much to remove at once…. it’s starting the cut that can be tricky. A starting pin is good, as mentioned. You can do this cut successfully without one, but you must approach the bit very slowly, and with a good grip. Once the cut is started, and your pattern is tightly against the bearing, you can increase your feed rate without a problem.

-- Charlie M. "Woodworking - patience = firewood"

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics