LumberJocks

Reply by cabs4less

  • Advertise with us

Posted on Jointers are too complicated!

View cabs4less's profile

cabs4less

235 posts in 3363 days


#1 posted 02-06-2011 10:38 PM

check your outfeed table hieght it should be the same hieght of the knives at the top of thier arc then check the knives wit a straight edge to the out feed table to make sure they are all the same hieght then raise both tables above the knives and check thier level they should be in line wit each other then reset the the out feed table to the same hight as the knives and set the in feed table to cut a 1/16 and run a 2x on eger without contacting the fence and check your cuts if its bumoy one of your knives is to high if its not cutting then your infeed table is not inline wit your outfeed then knives

-- As Best I Can


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com