LumberJocks

Reply by Fireball

  • Advertise with us

Posted on What causes burn marks on the table saw

View Fireball's profile

Fireball

71 posts in 5036 days


#1 posted 02-07-2008 12:40 AM

Gents,

The following crude method was used to check the fence to blade alignment. Marked a tooth on the blade and brought it as far forward as possible. Measurement = 10” exactly. Rotated that same tooth as far back as possible, distance from tooth to fence = 10 1/32”

Seems like this is what i want as the fence is toed slightly out to help avoid kickback.

I also took the blade off and cleaned it up. I don’t think it was too dirty, but do you guys think that it had enough junk on it to compromise cut quality?

I’ll be back out to the shop shortly to reinstall the blade and make a few test cuts. Hope all goes smoothly (no pun intended!)

100_1653

100_1654


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com