Reply by pfleming

I purchased one of the PCB222TS saws a few weeks ago. Sure there are a few things that could be upgraded, but for the price, it seems to be a pretty good saw. Of course, my last saw was a little China made job with the 5/8” slots too. One thing that I’ve noticed is that, even though the fence has some slop in it, if you wax the table top and fence slide areas, and apply a little pressure just under the lock on the fence when sliding the fence, it is actually very accurate and slides smoothly. My question is…..does anyone make an aftermarket ZCI or a better fence for this saw yet? If not, has anyone made a ZCI for it and how difficult was it, given the finger-style hold down in the rear of the blade opening?

-- Patrick, Mississippi