LumberJocks

Reply by ElChe

  • Advertise with us

Posted on How would I create this handle using my router table?

View ElChe's profile

ElChe

630 posts in 2308 days


#1 posted 01-11-2015 04:51 PM

Thx for updated pic. I’d dado out most of material on one side in a series of passes. With the last pass on the handle side leave enough material for the curve to be shaped in. Then double tape stick a runner to same thickness of stock on the side with waste removed. Start dadoing out the waste on other side ( again leaving enough wood to accommodate the curve). You can Affix a similar runner on that side for stability. For the curve I agree with prior poster that length of shaft on bowl bit will limit how high you can go with the lid detail. A card scraper with a radius may be the way to go if you don’t have enough bit.

-- Tom - Measure twice cut once. Then measure again. Curse. Fudge.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com