iPhone Charging Station

  • Advertise with us
Project by DonB posted 02-04-2014 05:04 PM 1503 views 1 time favorited 3 comments Add to Favorites Watch

We have new iPhones, so naturally we needed a charging station. I looked over some of the examples fellow Lumberjocks displayed and picked this one. Outside case and tray at rear/top of case is plywood. The two blue panels are 1/2” craft board from a Big Box. Front panel is pinned on the bottom, rear is pinned at the top for easy access and to hold phones in place. The 1/8” dowels that support the phones are covered with plastic tubing to cushion the phones and provide a stop for the lower panel.

-- DonB

3 comments so far

View Brett's profile


951 posts in 3605 days

#1 posted 02-05-2014 05:43 AM

Sweet, simple and to the point! I should make something like this for our phones.

-- Hand Crafted by Brett Peterson John 3:16

View DonB's profile


584 posts in 3538 days

#2 posted 02-05-2014 12:28 PM

Brett: If you desire, I’ll measure it and list sizes.

-- DonB

View Fishinbo's profile


11362 posts in 3021 days

#3 posted 02-10-2014 02:46 PM

Sleek charging station, like the simple design and colors. Well done!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics