Round End Table

  • Advertise with us
Project by JimYoung posted 01-31-2014 02:40 AM 1200 views 0 times favorited 2 comments Add to Favorites Watch

This was my second attempt at an end table. I based it on my first square arts and crafts table and used through tenons on the bottom of the legs and mortise and tenon joints under the top. I set up a quick plywood jig on my crassman 10” bandsaw to cut the top and cleaned it up on the disc sander. The crossed stretchers have a half lap joint in the middle.

-- -Jim, "Nothing says poor craftsmanship more than wrinkles in your duck tape"

2 comments so far

View mpmitche's profile


428 posts in 3829 days

#1 posted 02-02-2014 06:40 PM

Very sharp looking table well done. The through tenons look incredibly clean. I always struggle with getting those right and often use blind ones. Nice job, keep up the good work.

-- Mike, Western New York

View Fishinbo's profile


11362 posts in 3028 days

#2 posted 02-04-2014 04:24 PM

It looks great, like the round top and you have mastered those great joints. Great work!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics