Simple Table Saw Cove Jig

  • Advertise with us
Project by mwill87428 posted 03-07-2013 08:59 PM 3595 views 8 times favorited 3 comments Add to Favorites Watch

My wife wanted me to make a frame for a wall hanging and I decided to jazz it up with a slight cove on the face of the frame. I made a couple of guide rails for a jig and attached them to the main rails of the Incra fence. I tried to use the calculator on fine woodworking to get the angle for the rails but it didn’t give me an answer that would produce what I needed so I figured it out the hard way. I must have been fairly close cause the cove came out spot on. It was quite alot of work smoothing things out after machining. I have never tried this before and it was a fun project.

-- Max

3 comments so far

View AJswoodshop's profile


1057 posts in 3332 days

#1 posted 03-07-2013 10:01 PM

Great job on this! I’m sure it will come in handy!

View Oldtool's profile (online now)


3198 posts in 3246 days

#2 posted 03-08-2013 12:39 AM

Nice work on this jig, looks like a good accessory to your shop.

-- "I am a firm believer in the people. If given the truth, they can be depended upon to meet any national crisis. The point is to bring them the real facts." - Abraham Lincoln

View jumbojack's profile


1691 posts in 3680 days

#3 posted 03-09-2013 01:20 AM

I dont know if this is what you WERE looking for, but I have found it very useful.

-- Made in America, with American made tools....Shopsmith

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics