Project Information
I decided to replace my old speakerstands ( picture 6 ).
For a better look and to get my speakers up higher.
It's a simple construction with 3.9 inch screws and titebond.
When attatching the bottom and base to the centerbeam, i placed the centerbeam in a vise to have good control.
Then layed the pre-drilled bottom and base on top of the beam positioning the piece, and drilled one side.
then i applied titebond on the beam, and drove one screw in. Once one side was tightened i drilled and screwed the other side, since it hard to get 2 perfect drilled holes while trying to position the bottom (or base).
This was a fun and quik project, and i'm happy with the improvement.
Finished with a coat of Tung oil.
Made from oak.
Thanks for looking!
For a better look and to get my speakers up higher.
It's a simple construction with 3.9 inch screws and titebond.
When attatching the bottom and base to the centerbeam, i placed the centerbeam in a vise to have good control.
Then layed the pre-drilled bottom and base on top of the beam positioning the piece, and drilled one side.
then i applied titebond on the beam, and drove one screw in. Once one side was tightened i drilled and screwed the other side, since it hard to get 2 perfect drilled holes while trying to position the bottom (or base).
This was a fun and quik project, and i'm happy with the improvement.
Finished with a coat of Tung oil.
Made from oak.
Thanks for looking!