cutting board

  • Advertise with us
Project by andrewjock posted 01-07-2013 07:32 PM 855 views 0 times favorited 2 comments Add to Favorites Watch

the software we used was CBD DESIGNER. i used walnut cherry and oak. we used mineral oil as a finish. to make this board i had to cut multiple strips then glues them together and let them sit over night, after that i had to scrape all the glue off and sand it smooth, after that i had to cut that into more strips, tip them up on there side and glue them back together and basically repeat the above steps. then i used oil to finish it.

2 comments so far

View mbs's profile


1667 posts in 3552 days

#1 posted 01-09-2013 02:12 AM

I like the pattern and wood you selected. How thick is it? It looks pretty beefy.

-- Sorry the reply is so long. I didn't have time to write a short reply.

View andrewjock's profile


3 posts in 2713 days

#2 posted 01-09-2013 07:24 PM

the thickness varies between 1 in. 1 1/2 in. and 2 in.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics