cut-off or scrap bin

  • Advertise with us
Project by ChrisMc45 posted 05-11-2012 07:27 PM 1747 views 2 times favorited 2 comments Add to Favorites Watch

Finally added mobility to the big box of off-cuts and scraps. All from one sheet of plywood and some of the scraps that were in the bin to begin with. Nothing super-pretty, but if you look at the last picture you can see where I started, a big cardboard box that the movers put my scrap in…that was two moves and 8 years ago.

This new bin is on 4” casters, so I can move it around as needed. i did not show the Masonite dividers I put into each “cell” of the bin, they help to segregate the scrap as well as keep the pieces upright/vertical. The back of the bin acts as a place to hang most of my bar clamps with the twist-grips in the bin and the bars hanging out.

2 comments so far

View Enoelf's profile


192 posts in 3313 days

#1 posted 05-11-2012 08:43 PM

Very cool..Looks a lot like a planter that I setup in Sketchup for those 8×24 flowerboxes.
Thanks for sharing.
Well done.

-- Central Ohio, Still got 9 and 15/16 fingers!

View Martyroc's profile


2712 posts in 3356 days

#2 posted 05-14-2012 03:12 AM

As long as its functional, I think it came out great.

-- Martin ....always count the number of fingers you have before, and after using the saw.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics