fluting jig

  • Advertise with us
Project by cabmaker posted 03-08-2012 05:53 AM 2343 views 2 times favorited 1 comment Add to Favorites Watch

Someone had asked recently about how I did flutes on cylindrical pcs. This is a very simple and quick to make set up. I make them to accept a range of diameters. JB

1 comment so far

View Tokolosi's profile


678 posts in 3522 days

#1 posted 03-08-2012 04:16 PM

Thats a very good idea. I note that the ends of your workpiece is hollow or is that something slid over the cilinder so that you can clamp it?

-- “There is nothing like looking, if you want to find something. You certainly usually find something, if you look, but it is not always quite the something you were after.” ~ JRR Tolkien

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics