Project by paplou | posted 02-28-2012 02:44 AM | 1482 views | 1 time favorited | 8 comments | ![]() |
![]() |
This is a vanity I made for a close lady friend of mine. All oak with three maple drawers behind one door. The half spindles I turned on the lathe, which was a bummer to turn without a steady rest then cut it half. It kept flexing on me so I had to turn it with very light cuts. I added 1/4 inch oak strips on edge to enhance the top. 33 1/4 wide 18 inches deep to fit in her bathroom.
All my projects are made of rough cut lumber unless I pick some up at auctions.
-- PAPLOU
8 comments so far
a1Jim
home | projects | blog
118153 posts in 4547 days
#1 posted 02-28-2012 02:57 AM
A great looking Vanity ,I like the back splash and wood top.
-- https://www.artisticwoodstudio.com/videos
Martyroc
home | projects | blog
2712 posts in 3276 days
#2 posted 02-28-2012 03:05 AM
That’s a sharp looking piece, very nice
-- Martin ....always count the number of fingers you have before, and after using the saw.
Beginningwoodworker
home | projects | blog
13345 posts in 4643 days
#3 posted 02-28-2012 03:18 AM
Nice vainty.
SuburbanDon
home | projects | blog
487 posts in 3964 days
#4 posted 02-28-2012 04:19 AM
Looks good. Lot’s of stuff there.
-- --- Measure twice, mis-cut, start over, repeat ---
Ken90712
home | projects | blog
17919 posts in 4159 days
#5 posted 02-28-2012 10:53 AM
Great work, looks very nice.
-- Ken, "Everyday above ground is a good day!"
millzit
home | projects | blog
111 posts in 3272 days
#6 posted 02-28-2012 12:39 PM
nice job!
-- .......now cut that out!
Porchfish
home | projects | blog
862 posts in 3502 days
#7 posted 02-28-2012 01:37 PM
Elegant !
-- The pig caught under the fence is always the one doing all the squealing !
ratchet
home | projects | blog
1391 posts in 4757 days
#8 posted 02-28-2012 02:22 PM
Very nice indeed. Nice turning and a sweet looking top!
Have your say...