Project Information
I wanted to have a stand that i could move around in my garage shop and I wanted it to have easy access for storage lumber. I also have a table saw with a long extension that I wanted to nest at a right angle.
I used a bent conduit to mount an LED fixture above the saw and used a beach baby shelter as the dust screen to keep the dust from blowing everywhere.
Overall length is 10' and width of the door slab tables is 19.5."
The laminated legs are my experiment in relying on glue alone - no mechanical connectors holding them together. So far so good. I was able to cheat a little on the Miter saw because there is a good amount of weight on the backside which makes a good balance as not all of the weight had to be on the front side. I did use Kreg joints at the box beam below the saw table primarily because I didn't want to spend the time lining up so many points for dowels.
I used a bent conduit to mount an LED fixture above the saw and used a beach baby shelter as the dust screen to keep the dust from blowing everywhere.
Overall length is 10' and width of the door slab tables is 19.5."
The laminated legs are my experiment in relying on glue alone - no mechanical connectors holding them together. So far so good. I was able to cheat a little on the Miter saw because there is a good amount of weight on the backside which makes a good balance as not all of the weight had to be on the front side. I did use Kreg joints at the box beam below the saw table primarily because I didn't want to spend the time lining up so many points for dowels.