Table and Chairs the Rest of the story.

That is a neat construction method. Real sturdy..Nice job on it.

Jim

-- Jim Jakosh.....Practical Wood Products...........Learn something new every day!! Variety is the Spice of Life!!

Lock miter bit on the legs. Did you have an problems with setup?

-- I intended to be a woodworker, but turned into a tool and lumber collector.

Yes had set up problems. I had the 3/4 max infinity lock miter and their gage. The problem is that the stock needs to be slightly less than 3/4 for optimal fit. otherwise one side, or both are not going to mill at a sharp angle and will have a lip at the end. So. if you really need 3/4 stock in you project buy the larger lock miter bit. or adjust to cut one sharp and one with the ledge. Either all the top run sharp or all the bottom run sharp and then they will mate at 90degree angles. and look fairly good and not noticeable at all when you soften the edge with a sander or hand plain or scraper.

-- Illigitimii non carburundum sum

Yes had set up problems. I had the 3/4 max infinity lock miter and their gage. The problem is that the stock needs to be slightly less than 3/4 for optimal fit. otherwise one side, or both are not going to mill at a sharp angle and will have a lip at the end. So. if you really need 3/4 stock in you project buy the larger lock miter bit. or adjust to cut one sharp and one with the ledge. Either all the top run sharp or all the bottom run sharp and then they will mate at 90degree angles. and look fairly good and not noticeable at all when you soften the edge with a sander or hand plain or scraper.

-- Illigitimii non carburundum sum

This was also a bit tricky to get the right motrice angle for the backs so the “Lumbar cradle” can be created.

-- Illigitimii non carburundum sum