LumberJocks

End Grain Cheese Slicer

  • Advertise with us
Project by dustysawyer posted 06-06-2020 08:31 PM 350 views 0 times favorited 1 comment Add to Favorites Watch

My first venture into end graining. After grabbing some white oak sticks from the burn box and gluing up a small board, I decided to try the cheese slicing hardware referenced on other projects. Rather than cut the board down to the typical size, I did a plunge cut with a 1/8” router bit using a ready made groove tapering jig I also found in the burn box. (see 2nd pic) The jig probably should have been a little wider but it worked fine. I was very pleased with the hardware (for only 6 bucks) and I’m thinking about incorporating this slicing feature into a larger charcuterie board.





1 comment so far

View Woodmaster1's profile

Woodmaster1

1473 posts in 3357 days


#1 posted 06-06-2020 09:00 PM

I have always used jig on the table saw to cut the groove at an angle. I never thought about using the router this will open up some more design possibilities for me. Thanks for sharing. Now that did end grain with one type of wood try using three or four types. Great job on your first try.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com