LumberJocks

Downdraft Table

  • Advertise with us
Project by HankLP posted 05-01-2020 01:25 AM 467 views 0 times favorited 1 comment Add to Favorites Watch

Just finished this downdraft table including a reference stone on the left for flat sanding small pieces. It took less than a half sheet of 1/2” plywood, a 2’x4’ piece of 3/4” melanine shelving, and some left over 1/8” underlayment for the bottom/baffle. The 3/4” holes provide good airflow and can also be used as dog holes to keep material from sliding around on the slick surface while sanding. The 4” dust extraction is placed on the top so it won’t pick up screw, nails, or small pieces the fall through the 3/4” holes. The table also provides a 40” high work surface for general use as well as sanding… I use it a lot for finish work.





1 comment so far

View cmmyakman's profile

cmmyakman

288 posts in 3460 days


#1 posted 05-01-2020 01:25 PM

This is a great design. I like the way you kept the velocity up across the holes by placing the plates under the holes.

-- You can't fail if you don't give up.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com