LumberJocks

Old Scrap Up-scaling

  • Advertise with us
Project by Leginxx posted 02-21-2020 03:13 PM 428 views 0 times favorited 2 comments Add to Favorites Watch

A nice little hand made table from an Oak shelf that was being thrown away, very dirty but a lovely figure(i’m not sure if this type of oak with this figure has a specific name) once planed. The legs and apron are from a fascia board that was painted black and once planed revealed American Southern Yellow Pine.

The oak shelf was flattened with a number 7 Stanley and edge jointed after planing square. The pine was planed to get the paint off and sawn and then jointed to give about 40mm square profile. This then had mortices cut in the legs and tenons in the apron components. The legs were set at 10 degrees off vertical and tapered with a hand plane.

The oak top was given a couple of chamfers at different angles to add a bit of interest and to reduce the bulk at the edges . No power tools were used in this piece .





2 comments so far

View ralbuck's profile

ralbuck

6471 posts in 2947 days


#1 posted 02-21-2020 08:05 PM

Very nice table.

Fine wood rescue too!

I like reuse instead of throwing it away!

-- Wood rescue is good for the environment and me! just rjR

View swirt's profile

swirt

4934 posts in 3652 days


#2 posted 02-21-2020 08:18 PM

Nice save

-- Galootish log blog, http://www.timberframe-tools.com

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com