LumberJocks

Guitar stand

  • Advertise with us
Project by sapwood posted 02-20-2020 10:23 PM 641 views 4 times favorited 1 comment Add to Favorites Watch

Downloaded a stencil of this design from the web. Changed design from folding (attached with hinge in middle of top) to a non-folding design by creating a cross member (similar to Taylor Guitar stand design) and attached with pegs . Added some design embelishments into cross member. Would look better if sides were cut from single piece, but I’m using up leftover pre-finished tongue and groove bamboo flooring from a kitchen project.
Covered all exposed edges on front with leather to protect the guitar finish. Side angles at 14.5 degrees, and it is a very stable design.





1 comment so far

View Foghorn's profile

Foghorn

518 posts in 159 days


#1 posted 02-21-2020 03:42 AM

Well done. I’ve made some similar ones. You just have to make sure of your angles on the bottom and ensure they match the lean of the guitar. Good stuff!

-- Darrel

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com