LumberJocks Woodworking Forum banner

Project Information

I made this cutting board for a family friend. It is my first attempt at breadboard ends. I made it out of scraps of hard maple, soft maple, cherry, walnut, zebra wood, and oak dowels. I cut the tenons and grooves for the ends on the router table, grooved a slot for your fingers on each end to make picking it up or flipping it to the clean side easier. Then finished it with 4 coats of butcher block oil. Hopefully it holds up well.

Gallery

Comments

· Registered
Joined
·
6,567 Posts
Good practice if you plan to make BB ends for a dining table or something.
 

· Registered
Joined
·
122 Posts
Beautiful stripes on that board. I like the way you glued all together - the joint looks great!
 

· Premium Member
Joined
·
510 Posts
Great looking board. The ends are a good addition to this. Great job !!! Mel
 
Top