LumberJocks

Table saw outfeed table

  • Advertise with us
Project by TEK73 posted 04-28-2019 06:03 PM 621 views 2 times favorited 2 comments Add to Favorites Watch

As ny shop has limited space I buildt an fold down outfeed table for my table saw.
I mostely followed this plan:
http://www.rockler.com/how-to/building-outfeed-table-mount-table-stand-support/

I have followed the original design, except that I’m no fan of metallic locks – so I made the locks in wood instead (walnut). I also used a sheet of plywood for the dowtail instead of hardwood, as I had it available.
In the start I was a bit sceptical as the dowtail did not slide very well, but after a coat of liberon finish oil followed by a coat of Johnson wax it is sliding trough as it was made for sliding – and it was

I also had to offset the dowtail a bit to one side because it would otherwise interfer with the electrical connector on the saw.

-- It’s good to have an end to journey toward; but it is the journey that matters, in the end. - Ursula K. LeGuin





2 comments so far

View moke's profile

moke

1402 posts in 3231 days


#1 posted 04-30-2019 04:51 PM

Very well done, that will certainly be a great addition to your shop. Thanks for showing

-- Mike

View GeeDub's profile

GeeDub

3 posts in 1381 days


#2 posted 05-01-2019 11:39 PM

Nice job. I’ve had these plans in my workshop for quite some time with an intent to build it. You’ve inspired me to get started!

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com