LumberJocks

3D cutting board

  • Advertise with us
Project by OceansideLen posted 01-24-2019 03:31 PM 1464 views 2 times favorited 9 comments Add to Favorites Watch
3D cutting board
3D cutting board No picture No picture No picture No picture No picture
Zoom Pictures

My first 3D cutting board. Fun project but tough to get all of the joints to come together.

-- Len, Oceanside, CA





9 comments so far

View Sandon's profile

Sandon

93 posts in 2317 days


#1 posted 01-24-2019 04:34 PM

Wonderful!

-- Sandon

View AM420's profile

AM420

282 posts in 1124 days


#2 posted 01-24-2019 05:35 PM

What did you use to cut out the pieces? I assume the key to a project like this is dead-on accurate angles.

View ralbuck's profile

ralbuck

6526 posts in 3007 days


#3 posted 01-24-2019 05:35 PM

A very fine piece of usable kitchen art.

-- Wood rescue is good for the environment and me! just rjR

View OceansideLen's profile

OceansideLen

19 posts in 1027 days


#4 posted 01-24-2019 11:15 PM

First I used my Dewalt planer to insure that all pieces were the same size (width & height) Then i used my Dewalt miter saw set at 30 degrees and cut bunches of pieces using as stop block to insure they all got cut to the same length. Glue and rubber bands for some of the joints. Clamps for others. My next challenge is how to make this pattern as an end grain board. More fun!

-- Len, Oceanside, CA

View Richard's profile

Richard

11309 posts in 3773 days


#5 posted 01-24-2019 11:54 PM

Very Nice & Well Done Len!

-- Richard (Ontario, CANADA)

View Ivan's profile

Ivan

15866 posts in 3608 days


#6 posted 01-25-2019 11:10 AM

You can’t miss with that pattern….excellent job.

-- Ivan, Croatia, Wooddicted

View degoose's profile

degoose

7272 posts in 4095 days


#7 posted 01-26-2019 12:04 AM

For endgrain board, rip at 60 degrees. One small observation, grain orientation of each of the different timbers needs to be the same. IMHO. Otherwise a very good job.

-- Don't drink and use power tools @ lasercreationsbylarry.com.au

View DJHendriks's profile

DJHendriks

21 posts in 1056 days


#8 posted 01-26-2019 11:45 AM

that is really looking good!
I know how hard it is to get it right.
I like long grain boards, because of the grain, and because it is much harder to stay consistent

-- a mistake is quicker than me...

View coprtim's profile

coprtim

5 posts in 495 days


#9 posted 01-27-2019 01:17 AM

Looks good

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com