cube shelf

  • Advertise with us
Project by wakinews posted 11-16-2018 12:53 PM 794 views 0 times favorited 2 comments Add to Favorites Watch

I made the cube by cutting for sides of 3/4 inches thick and 4 corners at 1 1/4 inches. The inside curve was made by routing with a bullnose bit.I didnt have access to a big cutter to make a big enough radius so i then passed it on another profiling bit to increase the radius.I joined the pieces with pocket holes .and then I made the outer curve by making a 45degree cut and then sanding with an orbital sander after joining.

The project is yet to be completed.i will post the finished project soon. I thank you all very much for this forum and for your love of sharing ideas.

2 comments so far

View 000's profile


2859 posts in 1532 days

#1 posted 11-16-2018 03:01 PM

Good job! Was it hard holding the wood up against the router table?

Next one do the corners like this: (forget the pocket holes)

View wakinews's profile


23 posts in 812 days

#2 posted 11-16-2018 03:21 PM

Jbay,yes it was very hard on the router and I had to watch my fingers.
Thanks for idea on the will work well next time am varnishing.this time around I will
fill the pocket holes and paint it.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics