Pocket Hole Joinery Assembly Fixture

  • Advertise with us
Project by Bricofleur posted 05-20-2017 12:12 PM 1859 views 4 times favorited 7 comments Add to Favorites Watch

Holding pocket hole joinery components on edge has always been an issue, therefore a new jig. And here is mine. I’ve used Melamine because glue won’t stick to it, and I had everything in my scrap bins.

As shown, I’ve taken advantage of a groove already milled on the back by adding a cleat so it would ‘hook’ to the workbench edge or any work surfaces.

Two square perpendicular fences are required, leaving a 2” gap between for the stock. Note that a chamfer or a rabbet will capture any dust that may interfere. The jig can also be used with flat stock instead of using typical face clamps.

For more photos and all construction details, please take a quick look at this page of my blog.

Thanks for looking.


-- Learn from yesterday, work today and enjoy success tomorrow. --

7 comments so far

View steliart's profile


2895 posts in 3168 days

#1 posted 05-20-2017 02:40 PM

Yeap that will do it… good thinking also with the sand paper… nice fixture Serge !!!

-- Stelios L.A. Stavrinides: - I am not so rich to buy cheap tools, but... necessity is the mother of inventions !!!

View Ivan's profile


14918 posts in 3347 days

#2 posted 05-20-2017 04:16 PM

Very smart, as usual. I came up with something simillar when joining large and long boards with screews – to hold them in place while making pilot holes and screw them.

-- Ivan, Croatia, Wooddicted

View kiefer's profile


5671 posts in 3146 days

#3 posted 05-20-2017 06:55 PM

That should help with the assembly and keep thins nice and square .
Good jig idea and well done at low cost .


-- Kiefer

View  woodshaver Tony C   's profile

woodshaver Tony C

6765 posts in 3832 days

#4 posted 05-20-2017 09:27 PM

Nice idea! jigs will make life a lot easier!

-- St Augustine FL, Experience is the sum of our mistakes!

View Roger's profile


21010 posts in 3283 days

#5 posted 06-03-2017 12:31 AM

Nice jig Serge. Luv the sandpaper for “no-slippin”

-- Roger from KY. Work/Play/Travel Safe. Keep your dust collector fed. [email protected]

View GR8HUNTER's profile


6369 posts in 1192 days

#6 posted 06-03-2017 02:16 PM


-- Tony---- Reinholds,Pa.------ REMEMBER TO ALWAYS HAVE FUN

View mafe's profile


12096 posts in 3569 days

#7 posted 06-04-2017 01:37 PM

Less is plenty.
Fine detail with the sandpaper grip.
Best thoughts,

-- MAD F, the fanatical rhykenologist and vintage architect. Democraticwoodworking.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics