Tumbling Block Pizza Board

  • Advertise with us
Project by Mr. Budster posted 04-03-2010 01:18 AM 3546 views 10 times favorited 8 comments Add to Favorites Watch

This is a tumbling block board made from Black Walnut, Cherry, and Hard Maple. It’s roughly 12.5” in diameter and just under 1/2” thick.

8 comments so far

View bigike's profile


4057 posts in 3972 days

#1 posted 04-03-2010 01:29 AM

great work! i been trying to figure out the angle to get these blocks can you let me in on the secret?

-- Ike, Big Daddies Woodshop, http://[email protected]

View Mr. Budster's profile

Mr. Budster

17 posts in 3722 days

#2 posted 04-03-2010 01:54 AM

Angles are cut at 30 degrees. The link below shows the jig I use to cut the diamonds:

View jayjay's profile


639 posts in 3730 days

#3 posted 04-03-2010 04:03 AM

Great job. I’ve been contemplating building something like that. I just need to work up the patience.

-- ~Jason~ , Albuquerque NM

View WilcoFlier's profile


58 posts in 3697 days

#4 posted 04-03-2010 10:23 AM

Nice work!! Inspired by Escher??

-- Wilco Flier

View MShort's profile


1798 posts in 4102 days

#5 posted 04-03-2010 03:16 PM

WOW !!!! I like it. Great choice of woods to give it depth. Thanks for sharing.

-- Mike, Missouri --- “A positive life can not happen with a negative mind.” ---

View BritBoxmaker's profile


4611 posts in 3720 days

#6 posted 04-03-2010 09:26 PM

I believe the pattern is called Louis Cube after one on the French Kings of the 18th (?) century. I’ve used it myself for a veneer pattern on a writing slope but no way as good as this one. Splendid work Mr. Budster.


-- Martyn -- Boxologist, Pattern Juggler and Candyman of the visually challenging.

View Dennisgrosen's profile


10880 posts in 3799 days

#7 posted 04-13-2010 12:14 AM

looks great
thanks for sharing


View mikeH's profile


98 posts in 4975 days

#8 posted 06-02-2010 03:46 PM

nice looking cutting board. I would be afraid to use it, too nice. I am also from wi. watertown are ya close to that
mike H

-- mjhaines

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics