Bessey Revo Style Clamp Holder

  • Advertise with us
Project by EdsCustomWoodCrafts posted 02-26-2016 11:14 PM 1587 views 3 times favorited 1 comment Add to Favorites Watch

I invested in some 40” Bessey Clamps and they were still in the box because I had no where to put them .. I don’t imagine me owning too many of these clamps as they are so exspensive but what I do own (2 right now ) I want to take really good care of these.

So I built this little unit to contain them and some of there accesories that I might buy in the future ..

The dimensions is 24” wide x 6” deep x 15” high..

It’s made from some leftover 3/4” sanded plywood they I had left around from my drill holder unit ..

It’s basically a left & right sides with a rabbitted top and 1 through dado and 1 stopped dado in each side..

I made the fiingers out 3/4” plywood and placed ( i used a 3/8” drill bit and then a hand saw to cut the fingers out)a 3” wide solid support under the fingers to re-in force and then placed 3 little 2×3 supports under the clamp resting shelf to give it some rigidity ..

This unit only holds 10 clamps and like I said if I even own that I would consider myself lucky…

There great clamps especially on wide board glue ups.. I’ll get some smaller ones I don’t think I’ll need any longer ones then the 40”..

I hope you like it and it was a fun build

-- Thanks Ed “A bad day woodworking is better than a good day working. ~Author unknown” . Come check out my website for more about what I make and how at

1 comment so far

View Tooch's profile


2018 posts in 3366 days

#1 posted 02-27-2016 04:15 AM

Nice looking rack, out real nice for ya

-- "Well, the world needs ditch-diggers too..." - Judge Smails

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics