LumberJocks

Revamped into computer desk

  • Advertise with us
Project by paplou posted 10-02-2009 12:57 AM 1689 views 0 times favorited 1 comment Add to Favorites Watch

This started out being a cabnet out of a dentist office years ago. I started to make it into a rotor table but I built one on my table saw. The chair you see was an old office chair my job was throwing out. i reuphostered and it made my junk ( same place chair came from) desk look bad. i measured it and found it was to short so i had to cut it in half then put it back together and reposition drawers. I had a pile of rough cut oak not being used so i start facing front sides. The knot hole i filled with walnut carved to fit. The red panels on sides and insides are made out of the same material the chair is covered in. The desk is so heavy, it is made of 1 inch mdf. plus all the oak I added had to bring it in 4 pieces then put it together. hope the floor holds it. lol

-- PAPLOU





1 comment so far

View Rustic's profile

Rustic

3257 posts in 4602 days


#1 posted 10-02-2009 05:40 PM

I do the same thing, repurpose. Nice work looks like agood strong desk

-- www.carvingandturningsbyrick.com, Rick Kruse, Grand Rapids, MI

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com