Table Saw Jointing Jig

  • Advertise with us
Project by ixj posted 12-11-2015 09:24 PM 1918 views 3 times favorited 1 comment Add to Favorites Watch
Table Saw Jointing Jig
Table Saw Jointing Jig No picture No picture No picture No picture No picture
Zoom Pictures

This is a simple table saw jig for jointing the edges of boards. It’s sized for stock that is 1-in thick, but it can be adjusted with a few screws. I used the jig to joint 3 red oak boards for a bench top, and I ended up with nice tight glue lines.

It’s a little tricky to push the jig through the saw and keep it tight to the fence. A couple handles would probably make it easier to control, but they would also make it a little bulkier for storage.

There is a short write-up on the jig on my website at

1 comment so far

View Monte Pittman's profile

Monte Pittman

30560 posts in 3142 days

#1 posted 12-11-2015 09:30 PM

Very functional. Good job.

-- Nature created it, I just assemble it.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics