| Project by SalvagedWoodworks | posted 11-12-2015 08:32 PM | 1790 views | 2 times favorited | 8 comments |  |
 |
So I always wanted a smart tv for in my living room. So one day i decided to go out and buy one. but when i got it home it would not fit on the stand i already had it was too short by a mere 10 inches.
So i figured I just bought this thickness planner off a local buy and sell page.
And a jointer from the same buy and sell page.
I should use up some pallets that have been laying around a while.
I didn’t remember to take very many pictures of the process
but here is a picture that shows both before planer and after 
And this picture shows the stand before staining
and here is the completed stand after stain
in all it took one day to plane, measure, cut, glue, screw, and wood fill the entire project. I sanded and stained the same night and brought it into the house the following afternoon as i really needed it to sit under the tv i wanted to watch it after all.
Thanks for checking it out it was a fun build and i would do it again anytime.
-- In it for the Outcome, Not the Income
8 comments so far
Ivan
home | projects | blog
16790 posts in 3951 days
#1 posted 11-12-2015 08:56 PM
Thre’s nothing I like more than pallet projects. Awesome table.
-- Ivan, Croatia, Wooddicted
MT_Stringer
home | projects | blog
3183 posts in 4314 days
#2 posted 11-12-2015 09:14 PM
Looks good. That is my style of reusing pallet boards.
-- Handcrafted by Mike Henderson - Channelview, Texas
Knothead62
home | projects | blog
2600 posts in 4044 days
#3 posted 11-13-2015 02:58 PM
My wife has been dropping subtle hints about pallet wood projects. We have a pallet company about two miles from the house. People pick it up for firewood! Need to get down there with the truck. My complements on the great project. I have a planer and a router that I could use for joining.
MT_Stringer
home | projects | blog
3183 posts in 4314 days
#4 posted 11-13-2015 10:19 PM
...and a metal detector, right?
-- Handcrafted by Mike Henderson - Channelview, Texas
SalvagedWoodworks
home | projects | blog
48 posts in 2010 days
#5 posted 11-15-2015 07:35 AM
it sure doesn’t hurt to have a magnet in the tool box
-- In it for the Outcome, Not the Income
SalvagedWoodworks
home | projects | blog
48 posts in 2010 days
#6 posted 11-15-2015 07:36 AM
Thank you
-- In it for the Outcome, Not the Income
SalvagedWoodworks
home | projects | blog
48 posts in 2010 days
#7 posted 11-15-2015 07:37 AM
I always have hated to see good lumber go to waste
-- In it for the Outcome, Not the Income
Jeff Farquhar
home | projects | blog
23 posts in 2014 days
#8 posted 11-15-2015 03:49 PM
Great job! I like the contrast of the pulls to the rest of the stand.
Have your say...