Poor man's push block

  • Advertise with us
Project by jrm4424 posted 10-12-2015 02:48 PM 1307 views 0 times favorited 4 comments Add to Favorites Watch

I made this from scraps. The center brace is adjustable from the top, since I did not have any T-tracks to adjust from the front. I glued strips from those circular rubber pads that are used to keep rugs from slipping. Couldn’t put on a handle due to the adjusters on the top. Most of the unit is 3/4” scrap pine, 1/2” plywood, and the left hand brace is adjustable and is made of 1/4” plywood. The small “Y” at the front is to keep the center brace parallel.

-- Jim, West Virginia

4 comments so far

View kiefer's profile


5682 posts in 3177 days

#1 posted 10-12-2015 06:27 PM

Looks good and a great thing to use to keep the hands save and away from the blade and also gives better control of the work piece .
I made one a while ago and I sure like using it .

Thanks for posting this Klaus

-- Kiefer

View mariva57's profile


666 posts in 2514 days

#2 posted 10-12-2015 09:03 PM

Well done, good idea to adjusting higher.

-- The common man thinks. The wise man is silent. The stupid man discusses.

View Shuja's profile


270 posts in 2076 days

#3 posted 10-13-2015 02:47 PM


-- shuja

View helluvawreck's profile


32086 posts in 3376 days

#4 posted 10-13-2015 03:04 PM

Nice looking jig and very practical.

helluvawreck aka Charles

-- helluvawreck aka Charles,

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics