Coffee grounds measuring scoop

  • Advertise with us
Project by jiggles posted 08-24-2015 01:31 PM 1913 views 9 times favorited 4 comments Add to Favorites Watch

This scoop is about 3”L x 2”W x 1” Tall. The hole is about 11/16” deep and I used an 1 1/2” Forstner bit, the finger hole was made with 5/8” Fortner bit. Used an Olive oil as the finish. This was a quick project using minimal material. Started by drilling the two holes first, then to the table saw, then bandsaw and finally oscillating sander to complete shaping. Then minimal hand sanding and finishing. I had a little bit of chiseling to do on the inside of the handle to marry up the saw cuts and the hole for the finger hold.

-- Jiggles, Huntsville (Prison City), Texas

4 comments so far

View WoodNSawdust's profile


1417 posts in 2028 days

#1 posted 08-24-2015 02:27 PM

A good looking scoop.

-- "I love it when a plan comes together" John "Hannibal" Smith

View jiggles's profile


54 posts in 2129 days

#2 posted 08-24-2015 02:33 PM

Just what every workshop needs! Thx

-- Jiggles, Huntsville (Prison City), Texas

View Northwest29's profile


1703 posts in 3342 days

#3 posted 08-24-2015 04:55 PM

Nicely done scoop and great design. Good job.

-- Ron, "Curiosity is a terrible thing to waste."

View jiggles's profile


54 posts in 2129 days

#4 posted 08-25-2015 04:08 AM

Thanks Ron for the kudos

-- Jiggles, Huntsville (Prison City), Texas

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics