Project by TechTeacher04 | posted 02-15-2015 11:02 PM | 1585 views | 3 times favorited | 0 comments | ![]() |
![]() |
i designed this table based on the size of a small table my father used to use when he would grade technical drawings when he used to teach drafting. The material is reclaimed 2×10 stair treads. All nail holes were patched with oak plugs That were also reclaimed from scrap. I cut 2 tenons on each end of the vertical part of the leg. I used oak wedges to anchor the center cross piece. I used my power mortiser to cut all through mortices. I used my new surface sander to level the 3 piece legs before finish sanding. Minwax poly for finish.
0 comments so far
Have your say...