Bass Speaker Cabinet

  • Advertise with us
Project by Popsnsons posted 10-26-2014 03:27 AM 2535 views 0 times favorited 3 comments Add to Favorites Watch

I made this bass speaker cabinet at the request of a friend. Most of my projects don’t require plans and a cut list but I was able to use them in this case. There are 45 biscuits, so I cut 90 slots hoping that everything would line up correctly. Started with a 5×5 sheet of 1/2” Baltic Birch so I had to use my straight edge and skill saw until the pieces were small enough to run through my table saw. The speaker hole is 14” in diameter. He’ll finish it up by adding the speaker, electronics and some type of finish. I’m happy with the results. I hope it sounds good too. Keep on Rockin’.

-- Pops ~ In So Cal...

3 comments so far

View wseand's profile


2796 posts in 4501 days

#1 posted 11-10-2014 04:17 AM

Nicely done, I have made about 100 speaker boxes in my past life. Looking good.

View Popsnsons's profile


459 posts in 4441 days

#2 posted 11-10-2014 04:32 AM

Thank you wseand. It was a fun project.

-- Pops ~ In So Cal...

View pkrevbro's profile


7 posts in 3039 days

#3 posted 01-11-2015 05:25 PM

Very nice work on the cabinet.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics