Gravity Defying Wine holders

  • Advertise with us
Project by rockmolsen posted 08-22-2014 05:06 PM 1988 views 8 times favorited 2 comments Add to Favorites Watch

These were fun and easy to make – great for gifts. The directions can be found here -

I actually waste a paper template on my stock. I attach a paper template with spray adhesive. Drill the holes first, cut the bevel angle on the bottom with the table saw, rough out the shape on the band-saw. I attached the 1/4 plywood template to the rough cut stock with double sided tape, then over to the router table with a trim bit – perfect every time. A bit of sanding with a spindle sander and by hand. I use a trim router with 1/8 round-over bit to easy over the edges. If you have a stationary disk sander it makes adjusting the bottom bevel angle very easy. These were made from zebrawood. I finished with a couple coats of danish oil.

-- Rick --------The measure of who we are is what we do with what we have.

2 comments so far

View Brianthesawdustmaker's profile


31 posts in 2356 days

#1 posted 08-23-2014 03:41 AM

Looks great! I always love the look of zebrawood.

-- Brian, Omaha, NE... So many projects, so little time!

View Dave777's profile


303 posts in 4917 days

#2 posted 08-24-2014 04:26 AM

Thanks for the tips will have to give this a try your look great

-- the stone rejected by the builders will become the capstone

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics