Micro adjust for my New table saw

  • Advertise with us
Project by geekwoodworker posted 08-15-2014 09:06 PM 10483 views 45 times favorited 6 comments Add to Favorites Watch

Now that I have a new table saw I need to make new jigs to go with it. I got the basic design from Ron Walters
( ). I did modify it a bit by adding the micro adjust wheel that turns on the threaded rod (not by turning the rod). This way if the rod isn’t striaght it still works well without wobble and is more consistent. One notch adjusts the fence by .003”. The screws on the knob side are loose so when tightening the knob, the side slightly moves which allows it to clamp onto the rail. It works great.

I used this idea on my router fence ( ) and it works fantastic so thought it should work for the table saw also.


6 comments so far

View Northwest29's profile


1713 posts in 3779 days

#1 posted 08-15-2014 09:26 PM

Now this is just too cool. There have been a few prior posts with similar micro-adjusters for the table saw. This one is definitely a project I need to get busy and make for my TS. Thanks for the post and inspiration.

-- Ron, "Curiosity is a terrible thing to waste."

View NormG's profile


6574 posts in 4292 days

#2 posted 08-16-2014 04:32 AM

Great jig idea, thank you for sharing

-- Norman - I never never make a mistake, I just change the design.

View bluekingfisher's profile


1333 posts in 4268 days

#3 posted 08-16-2014 09:30 AM

Simple and effective jig, very useful for those exact dimensions when required.

-- No one plans to fail, they just, just fail to plan

View geekwoodworker's profile


378 posts in 2749 days

#4 posted 08-16-2014 11:05 AM

Thanks everyone. My previous micro adjuster was for a Delta Unifence and is a T-rail so I had to make this one and I love it. It is version 2 though as I didn’t like the prototype. So I did some googling and found the one by Ron Walters on woodgears. Works great so no more versions needed.

View Roger's profile


21055 posts in 4093 days

#5 posted 08-24-2014 08:26 PM

This’ll help you split some hairs. Nice one/two

-- Roger from KY. Work/Play/Travel Safe. Keep your dust collector fed. [email protected]

View BGST's profile


38 posts in 2070 days

#6 posted 05-14-2019 03:46 PM

What a great idea and necessary addition for our TSs. How did you connect the micro adjust wheel so it clicks a specific amount and then locks in place? Would it be possible for you to add a drawing of the plans? Thanks for showing this wonderful idea.

-- Barry, Edmonton, Alberta, Canada

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics